G-2 inflector review

Friday 24 Jun 2016, 08:00 → 18:40 US/Central

TD/IB3A conf. room (Fermilab TD/IB3A)

This is a review of the engineering design of the g-2 inflector magnet. The purpose of this review is to evaluate the status of the prototype design and manufacturing plans for the magnet, including cost and schedule.

agenda Agenda_Inflector_review_june2-v2.xlsx

document g-2_inflector_review_charge_2016-06-24-dist.docx

Slides Fermilab-Gm2-Infl-Rev-160624.pptx

Committee Executive Session

Overview of magnet parameters and new design

Convener: Vladimir Kashikhin (Fermilab/TD/MSD)

slides Inflector_Design_Review_062316_uploaded.pdf

Mechanical design, magnet fabrication and tooling

Convener: Steve Krave (Fermilab)

document brief_responses_to_reviewer_questions.docx

slides Inflector_Mechanical_design,_magnet_fabrication_and_tooling_Final.pptx

10:20 Coffee Break

Short model test and room temperature magnetic measurements

Convener: Thomas Strauss (FNAL)

slides MagneticMeasurements.pptx

Preliminary proposal for cold test

Convener: Thomas Strauss (FNAL)

slides TestPlan.pptx

Installation of New Inflector Cold Mass: The Concept

slides New_Inflector_Installation.pptx

Cost and Schedule

document 2016-05-25_Inflector_v3.xlsx

slides g-2_Inflector_Cost_and_Schedule.pptx

12:00 Lunch

Committee Executive Session

Questions from the Committee

14:15 Coffee Break

Preparing Answers

Answers to Committee Questions

Committee Executive Session / Preliminary Report Writing

Closeout