G-2 inflector review

Friday Jun 24, 2016, 8:00 AM → 6:40 PM US/Central

TD/IB3A conf. room (Fermilab TD/IB3A)

This is a review of the engineering design of the g-2 inflector magnet. The purpose of this review is to evaluate the status of the prototype design and manufacturing plans for the magnet, including cost and schedule.

agenda Agenda_Inflector_review_june2-v2.xlsx

document g-2_inflector_review_charge_2016-06-24-dist.docx

Slides Fermilab-Gm2-Infl-Rev-160624.pptx

8:30 AM → 8:50 AM Committee Executive Session

8:50 AM → 9:30 AM Overview of magnet parameters and new design

Convener: Vladimir Kashikhin (Fermilab/TD/MSD)

slides Inflector_Design_Review_062316_uploaded.pdf

9:30 AM → 10:20 AM Mechanical design, magnet fabrication and tooling

Convener: Steve Krave (Fermilab)

document brief_responses_to_reviewer_questions.docx

slides Inflector_Mechanical_design,_magnet_fabrication_and_tooling_Final.pptx

10:20 AM → 10:35 AM Coffee Break

10:35 AM → 10:55 AM Short model test and room temperature magnetic measurements

Convener: Thomas Strauss (FNAL)

slides MagneticMeasurements.pptx

10:55 AM → 11:15 AM Preliminary proposal for cold test

Convener: Thomas Strauss (FNAL)

slides TestPlan.pptx

11:15 AM → 11:30 AM Installation of New Inflector Cold Mass: The Concept

slides New_Inflector_Installation.pptx

11:30 AM → 12:00 PM Cost and Schedule

document 2016-05-25_Inflector_v3.xlsx

slides g-2_Inflector_Cost_and_Schedule.pptx

12:00 PM → 1:00 PM Lunch

1:00 PM → 2:00 PM Committee Executive Session

2:00 PM → 2:15 PM Questions from the Committee

2:15 PM → 3:15 PM Coffee Break

Preparing Answers

3:15 PM → 4:00 PM Answers to Committee Questions

4:00 PM → 5:10 PM Committee Executive Session / Preliminary Report Writing

5:10 PM → 5:30 PM Closeout